I guess like many of you running trail cameras, I too have gone through the numerous options of 'powering' them using the most cost-effective manner. Buying Energizer batteries for multiple trail cameras (14 as of this writing) soon became WAY expensive. Using external power (12v batteries) was cost effective but as we all know, maintaining their 'charge' required either a recharge every 6 to 8 months, or maintaining a supply of batteries to swap out when required... my chosen method. I run my 'trap' cell cameras pretty much in the dark woods so I never really thought about trying to supply them with power through solar... UNTIL I saw this Herd360 X3 solar panel. Several key points caught my interest here; First: there were several reviews from people who not only were using Reconyx cameras, my chosen camera preference, but the X3 actually came supplied with the 'correct' connection cable albeit only 4' in length. These reviews sang the praises of the X3 panel through first-hand experience. Second: My conversation with Mike at Herd360. Mike and I had a lengthy conversation and I could not have felt any more confident that his new X3 was going to eliminate my need to maintain a 'Re-Charging Schedule' for my external batteries any longer... the X3 panel should, given what I have learned, be able to maintain a consistent power supply to my cameras (4k Reconyx's). Now here's where my 'BETTER MOUSE TRAP' comes into play and yes, I did discuss this with the expert... Mike. I wanted to actually make an 'Extended Length' cable that would allow me to position the X3 higher in the tree where the panel would have access to the sun. My logic was simple; if the X3 worked in little sunlight, it should work even BETTER with sunlight... RIGHT! Mike admitted that he's never 'tried' out this hypothesis, but suggested that I use landscaping wire, 14ga, if I wanted to give it a go. By the way, Mike did tell me that he thought the X3 would work 'as-is'. However, with his encouragement, I set out to create my better mousetrap. After doing a bit of on-line research, I was able to come up with all the components necessary to make my extended cable (I chose a length of 25' - plenty high enough for me) and these components enabled me to use 14ga wire from one end to the other... nice! I have included some pics of how I did this and the end result. I tried to show you the exact components I used and just how easy and inexpensive this project was. Last last thing I will say is this, although I have not yet hung my (test) X3 panel, I did do a simple little test that gives me all the confidence in the world that this will work. After charging my X3 panel, I attached the supplied 'Reconyx' cable (4') to the X3 panel. I then tested the 'voltage' at the Barrel Connector, the camera's end... It read 12.3v. I next connected my 25' Better Mousetrap cable and tested it... 12.3v! Absolutely NO LOSS of voltage! My plan is to run this first 'test' all winter long on my Reconyx camera that gets a good amount of activity (I have NO food plot cameras... just trail activity) and if things go as expected, I will be outfitting all my cameras with this setup and getting away from having to maintain my external batteries through recharging/exchanging.